Worksaver CS-694 Manuel d'utilisateur

ATTENTION! SAFETY RULES 1. Read instruction manual and make sure all operators are knowledgeable on correct operation of equipment and

Page 10 Ref. No Part No. DescriptionNo. Req'd46420748PTO Assembly, Complete163420764PTO Half, Tractor End164420765Plastic Shield Assembly, Oute

Page 11 GEARBOX COMPONENTS OPTIONAL AGITATOR COMPONENTS Ref. No.Part No. DescriptionNO. REQ.45 420747 Gearbox, 3-Hole (Complete) 147 420749 Gearbo

SAFETY PRECAUTIONS MOST ACCIDENTS OCCUR BECAUSE OF NEGLECT OR CARELESSNESS. AVOID NEEDLESS ACCIDENTS BY FOLLOWING ALL OF THE SAFETY PRECAUTIONS LIS

To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator

Measure the distance between the ends of the two shafts (Dimension “A”, Figure 1). Each half of the PTO should be equal to dimension

OPERATING INSTRUCTIONS 1. Right-hand or left-hand reference is determined by standing at the rear of the seeder/spreader and facing in the direction

MAINTENANCE 1. The hopper should be washed after use, especially after use with corrosive material such as fertilizer, salt,

SPREADING CHART FOR FERTILIZERS NOTE: Spread widths of fertilizer will vary according to type. Always check actual spread width and application rate.

SPREADING CHART FOR SEED NOTE: Spread Chart settings are approximate – always make a trial run to check actual application rate. NOTE:

EXPLODED PARTS DRAWING FOR CS SERIES SPREADERS Page 8

REPAIR PARTS FOR CS SERIES SEEDER/SPREADERS Page 9 Ref. No Part No. DescriptionNo. Req'd1420701Frame, XA12 420702 Bolt, Hex Head, M8 x 20, Zinc